Putin Slapper
Made by Mellow_Labs / 3D Printing
About the project
It slaps putin in the face over and over again what else is there to say
Project info
Difficulty: Easy
Platforms: Raspberry Pi
Estimated time: 3 hours
License: Creative Commons Attribution CC BY version 4.0 or later (CC BY 4+)
Items used in this project
Story
After Russia's invasion of Ukraine I wanted to do something to spread awareness, as well as flipping a middle finger to you know who. After thinking about it for a bit I had a plan a robot that slaps his face.
I leveraged the 3D printing community, and found a model of his head and a suitable hand and 3D printed them.
I posted a couple of stories on my Instagram when I was printing the the head, and I could few concerned messages about what I was up to.
Then I had to remove the head from the torso, I could have done this in software but it was much more satisfying doing it with a red hot knife. and then I popped it on a spring.
To finish it off I printed a holder for the servo and the head. after posting it to Reddit they decided that the slap wasn't enough, so I came back to it and added another feature. A punch.
if you'd like to see extra footage I made a YouTube video about it with more details.
Credits
Related products
Leave your feedback...